Irrigation

(Qty 25) 1/4" Barbed Tee Connector Learn More

Sturdy tubing for all your irrigation needs, or to make your own hydroponics systems. Learn More

The Octa-Bubbler is an eight-outlet, pressure compensating, low-flow irrigation device. Along with 8 flow-controlled swivel barbed outlets, it has a 1/2” FPT inlet thread base for installation on standard risers, and a backflow prevention device for added protection.

Learn More

The Octa-Bubbler is an eight-outlet, pressure compensating, low-flow irrigation device. Along with 8 flow-controlled swivel barbed outlets, it has a 1/2” FPT inlet thread base for installation on standard risers, and a backflow prevention device for added protection.

Learn More

The Octa-Bubbler is an eight-outlet, pressure compensating, low-flow irrigation device. Along with 8 flow-controlled swivel barbed outlets, it has a 1/2” FPT inlet thread base for installation on standard risers, and a backflow prevention device for added protection.

Learn More

Use to connect 3/4" tubing to 1/2" tubing. Learn More

(25) 1/4" Barbed Straight Connector Learn More

(Qty 5) 3/4" Barbed Tee Connector Learn More

(Qty 5) 1" Barbed Elbow Connector Learn More

More effective irrigation of all types of pots/containers in all growing mediums. Drip emitters and stakes only provide a single point of irrigation making it hard for water/nutrient solution to evenly saturate a container. The water ring has 54 perfectly positioned pores to evenly irrigate containers eliminating dry pockets of growing medium. Kit contains 3 removable stakes to keep water rings in place around each plant. The water ring can also be used without the stakes if desired. The water ring has a 1 inch gap on one end to allow it to be placed around large plants without damaging the stalks. Can be used indoors or out in soil or hydroponics. Durable construction allows for years of use. Can be easily cleaned between growing cycles. Create your own flexible irrigation kits easily and cheaply with any ½ inch I.D. tubing and ½ inch fittings (not included). Please note that adding ½ inch ball valves may be necessary to create an even flow to all water rings in large installations. Learn More

Sturdy tubing for all your irrigation needs, or to make your own hydroponics systems. Learn More

4" Support Stakes Use to hold drippers in position next to plants to be watered. Position a support stake in the soil halfway between the center and the outer edge of the container. Place the dripper end securely in the yoke of the stake, allowing approximately 1" overlay. Adjust the depth of the stake leaving a minimum 1" air gap between the dripper outlet and the overflow rim of the container. 6" Support Stakes Use with 1/4" Tubing Use to hold tubing with drippers or tubing ends of the Hydroport Watering Manifold, Drip Star, Multiplex and Four Outlet Bubblers. Learn More

(Qty 5) 1" Barbed Straight Connector Learn More

(Qty 10) 1/2" Barbed Tee Connector Learn More

(Qty 10) 1/2" Barbed Elbow Connector Learn More