This pump is a magnetically driven centrifugal water pump. It has no seals to wear and contains no oil. The pump can be used submerged or inline. Inline means connections are made directly to the pump inlet and outlet ports, which have 1" NPT threads. All electrical components are encapsulated in epoxy with no seals to wear or break. The energy used is approximately 1/2 of regular motor drive pumps. The prefilter screen is provided to use in situations where deposits in the water could clog or damage the pump. This helps give uninterrupted service.
Centrifugal pumps cannot pull water from a lower level. In order to start, pump must be below water level and filled with water. Unless the air can escale from the outlet, the pump will not start. No not use glues or solvents to connect the pumps threaded fittings. Use Teflon pipe tape. The pump cover is not designed to support long pipe runs or correct pipe misalignment.
Pump is intended to pump water only. It cannot be used to pump oils, solvents or gasoline. Although the pump will continue to run if there is no water, after 30 minutes damage may occur if allowed to run dry.
Specs
- Mag Drive 190 GPH
- 190 GPH maximum flow with a 7’ shut-off.
- 10’ grounded power cord.
- Built-in adjustable flow control.
- 3/8” to 1/2” NPT.
- Ceramic shaft.
- Foam pre-filter and elbow included.
- Three year limited warranty.
- Mag Drive 250 GPH
- 250 GPH maximum flow.
- Max height 7’.
- 10’ grounded power cord.
- Operates submerged or in-line.
- 1/2” NPT.
- Ceramic shaft.
- Foam pre-filter included.
- Three year limited warranty.
- Mag Drive 350 GPH
- 350 GPH maximum flow
- Max height 10.5’
- 10’ grounded power cord
- Operates submerged or in-line
- 1/2” NPT
- Ceramic shaft
- Foam pre-filter included
- Three year limited warranty
- Mag Drive 500 GPH
- 500 GPH maximum flow.
- Max height 10.5’.
- 10’ grounded power cord.
- Operates submerged or in-line.
- 1/2” NPT.
- Ceramic shaft.
- Foam pre-filter included.
- Three year limited warranty.
- Mag Drive 700 GPH
- 700 GPH maximum flow
- Max height 12.5’
- 10’ grounded power cord
- Operates submerged or in-line
- 1/2” NPT
- Ceramic shaft
- Foam pre-filter included
- Three year limited warranty
- Mag Drive 950 GPH
- 950 GPH maximum flow
- Max height 15’
- 10’ grounded power cord
- Operates submerged or in-line
- 3/4” NPT
- Ceramic shaft
- Foam pre-filter included
- Three year limited warranty
- Mag Drive 1200 GPH
- 1200 GPH maximum flow
- Max height 15'
- 10' grounded power cord
- Operates submerged or in-line
- 3/4" NPT
- Ceramic shaft
- Foam pre-filter included
- Three year limited warranty
- Mag Drive 1800 GPH
- 1800 GPH maximum flow
- Max height 22'
- 10' grounded power cord
- Operates submerged or in-line
- 3/4" NPT
- Ceramic shaft
- Foam pre-filter included
- Three year limited warranty
- Mag Drive 2400 GPH
- 2400 GPH maximum flow
- Max height 22'
- 10' grounded power cord
- Energy efficient
- Operates submerged or in-line
- 1" NPT
- Ceramic shaft
- Filled with epoxy, not oil
- Pre-filter included
- Three year limited warranty
